Why is my Sony speakers not working?

Try different cables to verify this is not a bad set of cables. Try setting the Audio/Video (A/V) receiver to a different Surround Sound mode. Check each speaker to make sure they are properly connected to the A/V receiver. Perform a Test Tone function to verify if the speakers are working correctly.

What can cause no sound from speakers?

Check the speaker connections. Examine the wires on the back of your speaker and make sure your speakers are plugged into the proper location. If any of these connections are loose, plug them back in to secure the connection. A loose connection could be the reason you have a speaker with no sound.

Why are my surround speakers not working?

Verify that the rear surround speakers are properly connected to the Audio/Video (A/V) receiver. For Dolby® ProLogic surround sound, the center-channel mode must be set to NORMAL or WIDE. If your source is a DVD or Blu-ray Disc® player, verify that the surround sound is enabled in the menu for the player itself.

How do I reset my Sony receiver?

Press and hold down the MUTING and MUSIC buttons. While holding down the MUTING and MUSIC buttons, press and release the POWER button to turn the A/V receiver on. Wait approximately 5 seconds and then release the MUTING and MUSIC buttons.

Why is my audio not working in my car?

Blown Fuse: One of the most common reasons for a car radio to stop working is a blown fuse. Damaged Speaker Wires – If your car radio will turn on, but you’re not getting sound (or are getting sound from just one or two speakers), the culprit is most likely a speaker wire that’s been damaged.

Why is my sound not working in my car?

Typically when a car stereo produces no sound it’s usually caused by a shorted or grounded wire, defective speakers, faulty head unit/fuses, or setup is not yet complete with your radio unit. We will show you how to break down each step correctly so you can start jamming away again on the road!

How do I reset my Sony surround sound system?

Unplug the power cord and confirm that the STANDBY indicator is not lit. Then pluh back in the power cord and turn on the system. At the same time, press and hold the FUNCTION and ON/Standby buttons until RESET appears on the display window.