How much does it cost to get a powered subwoofer installed?

Vendors charge around $100 to install a subwoofer, but the cost will run over $300 for complicated installation work. Better still is to purchase some or all of your components, including the subwoofer, from a dealer who will install it for you as part of the purchase price.

What wires are needed for a subwoofer?

For the installation, you need:

• A 20 ft (6.1 m) power wire.
• A ground wire at least 3 ft (0.91 m) long.
• A 15 ft (4.6 m) RCA wire with both red and white connectors.
• A 15 ft (4.6 m) blue remote wire.
• Speaker wire, which can also be bought separately.
• A 50-amp in-line fuse and fuse holder.

Can I connect active subwoofer to an amplifier?

While a powered subwoofer (active subwoofer) does not need to be connected to an amplifier since its amp is built-in, you can connect a powered sub to an amp for data transmission only. To do this, connect the two with RCA cables and plug the powered sub into the wall for its power source.

How long does subwoofer installation take?

With all of the above caveats in mind, installation of a car stereo should take anywhere from one to four hours. However, times may vary and the only way to get an accurate quote on car stereo installation is to take it into a car audio shop.

Can you use a subwoofer without an amp?

Subwoofers are designed to increase the bass frequencies, resulting in a deep, thumping sound. In most cases, they are paired with an amplifier to boost the sound. If you do not have the funds for both components, you can still hook up a subwoofer without an amplifier; it simply involves a little more know-how.

What do I need to install a powered subwoofer?

Your powered sub does not come with the necessary wiring, so be sure to purchase an amp wiring kit that includes the wiring and fuses you’ll need. First, disconnect the negative battery terminal to protect you and your gear during installation. Next, run the power cable from the battery to the powered sub.

How to connect an amplifier to a subwoofer?

Connect the red power cable to the amplifier. 1 The power slot may also be labeled as battery or 12v. 2 The slot is often controlled by a small screw. Turn it counterclockwise with a Phillips screw to open it. Close it back up after inserting the wire. 3 If you’re using a combination amp and subwoofer, look for wiring slots on the back of it.

How to install a powered subwoofer-Crutchfield?

2002 civic LX sedan, installing S/O B8PTD powered sub under driver seat. head unit is Alpine CDA-9827. am I able to get more specific instructions related to my vehicle? thanks! Brendan, You’d install that powered sub just like the article/video describes.

Where do you run the power cable to a subwoofer?

Run the power cable from the battery to the subwoofer. The power cable is often the longest wire in a wire kit and is colored red, but make sure to check the labeling. Lower the wire down into the engine compartment and through the firewall hole until it emerges inside your car. Then, go inside your car to pull it all the way to the subwoofers.

https://www.youtube.com/watch?v=6DTiNkgOnuI